6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-52
(8) Move the tool carriage to the left side, and then spread a suitable quantity of SUMITEC 305 on the
two areas of the Y drive belt.
Rear Side
(9) Loosen and re-tighten the M3L6 TP head screw while pushing the Y drive belt tension arm in the
direction of the arrow to loosen the Y drive belt again.
(10) Attach the Y-exible cable guard to the frame.
(11) Loosen the M3L6 TP head screw holding the Y drive belt tension arm. Re-tighten the M3L6 TP
head screw after the Y belt tension is automatically adjusted by the Y belt tension spring.
(12) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
