GRAPHTEC CE LITE-50 - Page 90

6 DISASSEMBLY AND REASSEMBLY
CE LITE-UM-251-9370 6-72
(22) Remove the two M2.6L10 self-tapping screws and spacers holding the left side of the media guide.
M2.6L10 self-tapping screws
(23) Remove the E-ring holding the drive roller shaft on the right side frame to detach the washer and
the bearing.
(24) Remove the Y drive belt (See subsection 6.2.22.).
(25) Remove the M3L6 TP head screw holding the upper slide shaft on the right side frame.
(26) Remove the two M3L6 TP head screws holding the slide shafts on the left side of the frame.
On the right frame, remove the
screw of the upper slide shaft.