GTS iMAPLA series - Important Information and Notes; Personnel Qualifications and Intended Use

Issue 08/2013 Page 6
MAPLA- Modular energy supply system for load lifting magnets
Important information and notes
1 Important information and notes
1.1 Qualied personnel
The unit or system may be installed and operated in connection with this
manual. Installation, commissioning and operation of aunit or system must
only be performed by qualied personnel.
Qualied personnel within the meaning of the technical safety information
in this manual are persons with the authorisation to put devices, systems
and circuits into service, to ground them, and to label them, according to
technical safety standards.
1.2 Intended use
The iMAPLA system described in this manual is amodular energy generation
system for lifting magnets.
The iMAPLA system is designed for use as apermanently installed power
generation system in excavators or material folding machine.
y The GTS iMAPLA system is only for use for suitable lifting magnets with
suitable rated voltage. Always follow the manufacturer's instructions from
the supplier of the lifting magnet and their safety instructions.
y Only use the iMAPLA system according to the voltage and performance
data on the rating plate.
y Do not connect the iMAPLA system to other power distribution or
generation systems (e.g.domestic installations, power distributors on
building sites, other generators or the public electricity supply network).
y Operate the iMAPLA system at the nominal speed.
y Only connect an appropriate lifting magnet to the control unit. Before
using ohmic or other loads, consult the manufacturer on their suitability
for use. Changes in circuits - parallel or between controller and lifting
magnet are not allowed.
y Connecting dierent iMAPLA systems in parallel or with other systems is
not allowed.