GW Instek PEL-2002 - Command Details; Common Commands

COMMAND DETAILS
23
COMMAND DETAILS
The Command details chapter shows the detailed
syntax, equivalent panel operation, and example
for each command. For the list of all commands,
see page16. Before programming the PEL-2000
electronic load, please become familiar with the
Status registers, detailed on page131.
Common commands ................................ 24
Abort Subsystem ...................................... 30
Channel Subsystem .................................. 31
CONFIGURE Subsystem .......................... 34
Utility Subsystem ..................................... 45
Current Subsystem ................................... 50
FETCH Subsystem ................................... 64
LOAD Subsystem ..................................... 68
Measure Subsystem ................................. 72
MODE Subsystem .................................... 77
Program Subsystem ................................. 79
Resistance Subsystem .............................. 87
RUN Subsystem ....................................... 98
SHOW Subsystem .................................... 99
SPECIFICATION Subsystem .................... 101
STATUS Subsystem ................................. 105
PEL-2000 Programming Manual
24
Common commands
*CLS ............................................................................. 24
*ESE ............................................................................. 25
*ESR? ........................................................................... 25
*IDN? ........................................................................... 26
*OPC ............................................................................ 26
*RCL ............................................................................. 27
*RDT? ........................................................................... 27
*RST ............................................................................. 27
*SAV ............................................................................. 28
*SRE ............................................................................. 28
*STB? ........................................................................... 29
*TRG ............................................................................ 29
*CLS
Status Command
Description
Clears:
Channel Status Register
Channel Summary Register
Questionable Status Register
Standard Events Register
Operation Status Register
Error Queue
When the *CLS command follows a program
message terminator <nl>, the following is cleared:
Output Queue
MAV bit
See page131.
Syntax *CLS
Example *CLS