GW Instek PEL-2002 - SPECIFICATION Subsystem; Specification[:Pass]; Specification[:Pass]:Channel;Voltage;Current

COMMAND DETAILS
101
SPECIFICATION Subsystem
:SPECification:UNIT ................................................. 101
:SPECification[:PASS]? .............................................. 102
:SPECification[:PASS]:CHANnel/VOLTage/CURRent?
................................................................................... 102
:SPECification:VOLTage:H/L/C ................................ 103
:SPECification:CURRent:H/L/C ................................ 103
:SPECification:TEST: ................................................. 104
:SPECification:UNIT
Channel Specific
Command
Description
Sets the Go/NoGo (specification) units as
percentages or values.
Syntax :SPECification:UNIT PERCENT/0, VALUE/1
Parameter PERCENT/0, VALUE/1 Go/NoGo Unit
PERCENT/0 Percentages
VALUE/1 Values
Example :SPEC:UNIT PERCENT
Sets the Go/NoGo limits
as percentages
Query Syntax :SPECification:UNIT? <NR1>
Return Parameter <NR1> Go/NoGo Unit
0 Percent
1 Value
Query Example :SPEC:UNIT?
0
The Go/NoGo
(specification) units are
set as percent.
PEL-2000 Programming Manual
102
:SPECification[:PASS]?
Channel Specific
Command
Description
Displays if the Go/NoGo (specification) limit has
passed/failed for the current channel used.
Query Syntax :SPECification[:PASS]?
Return Parameter <NR1> Go/NoGo Specification
0 Fail
1 Pass
Query Example :SPEC:PASS?
0
Go/NoGo has failed
Query Example :SPEC?
0
Go/NoGo has failed
:SPECification[:PASS]:CHANnel/VOLTage/
CURRent?
Channel Specific
Command
Description
Queries if the voltage, current or channel has
passed/failed the Go/NoGo (specification) limits.
VOLTageCC, CR mode, CURRentCV mode
Query Syntax :SPECification[:PASS]:CHANnel/VOLTage/CURRent;?
Return Parameter <NR1> Go/NoGo Specification
0 Fail
1 Pass
Query Example :SPEC:PASS:VOLT?
0
The test has exceeded
the Go/NoGo voltage
limits.
Query Example :SPEC:VOLT?
0
The test has exceeded
the Go/NoGo voltage
limits.