GW Instek PEL-2002 - SHOW Subsystem; SHOW:Show[:Display] Single Channel; Show[:Display] Dual Channel

COMMAND DETAILS
99
SHOW Subsystem
:SHOW[:DISPlay] single channel ................................ 99
:SHOW[:DISPlay] dual channel ................................ 100
:SHOW[:DISPlay] single channel
Channel Specific
Command
(Dual channel module)
Description
Sets the display mode of the load module of the
specific channel.
Syn tax :S HOW:D ISPlay [LVI , LVW, LI W, RVI, RVW, RIW, LRV,
LRI, LRW, LRS, LIRV, LVRI, LVRI]
Parameter <aard> Load module display (dual channel)
LVI Left channel, voltage/current
LVW Left channel, voltage/power
LIW Left channel, current/power
RVI Right channel, voltage/current
RVW Right channel, voltage/power
RIW Right channel, current/power
LRV Left and right channel voltage
LRI Left and right channel current
LRW Left and right channel power
LRS Left and right channel load on time
LIRV Left channel current, right channel
voltage
LVRI Left channel voltage, right channel
current
Example :SHOW:DISP LVI
Show the left channel
voltage and current on
the load module display.
PEL-2000 Programming Manual
100
:SHOW[:DISPlay] dual channel
Channel Specific
Command
(Single channel module)
Description
Sets the display mode of the load module of the
specific channel.
Syntax :SHOW:DISPlay [VI, VW, IW, S]
Parameter <aard> Load module display (single channel)
VI Voltage/current
VW Voltage/power
IW Current/power
S Load on time
Example :SHOW:DISP VI
Shows voltage and
current on the load
module display.