GW Instek PEL-2002 - Current:dynamic:l1;L2

COMMAND DETAILS
55
Query Example :CURR:STAT:HIGH:BVALu
e? MAX
20.4000
Returns the maximum
current allowed for the
channel in high range
mode. (PEL-2020)
:CURRent:STATic:HIGH:RISE/FALL
Channel Specific
Command
Description
Sets the high range rising/falling slew rate.
Syntax :CURRent:STATic:HIGH:RISE/FALL <NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew Rate
RISE/FALL 0.8A/uS Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL 1 Sets the rising/falling slew
rate to 1A/uS
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example :CURR:STAT:HIGH:RISE
1.1
Sets the rising slew rate
to 1.1A/uS.
Query Syntax :CURRent:STATic:HIGH:RISE/FALL?[MIN, MAX]
Return Parameter <NR2>[MAX, MIN] Slew rate
1 Unit=1 amp/uS Returns the slew rate.
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :CURR:STAT:HIGH:RISE?
MAX
0.8000
For high range CC mode,
the maximum value for
the rising slew rate is
0.8000 A/uS for the
specific channel.
PEL-2000 Programming Manual
56
:CURRent:DYNamic:L1/L2
Channel Specific
Command
Description
Sets the current levels (Level 1 & 2) for CC
dynamic mode. The command is range dependant.
If the current range is Low, then the settings will
only apply to low range.
Syntax :CURRent:DYNamic:L1/L2 <NRf+>[A]
Parameter NRf+[A] Current
L1 1 Sets L1 to 1 Amp.
L2 2 Sets L2 to 2 Amps.
L2 2A Sets L2 to 2 Amps.
L1/L2 MIN Sets L1 or L2 to the
minimum level for the
specific channel.
L1/L2 MAX Sets L1 or L2 to the
maximum Level for the
specific channel.
Example :CURR:DYN:L1 10
In CC dynamic mode,
Set L1 (level 1) to 10
amps.
Query Syntax :CURRent:DYNamic:L1/L2? MIN, MAX
Return Parameter <NR2>[MAX, MIN] Current
1 unit= 1 amp Returns the current of
L1/L2, or the maximum or
minimum current allowed.
Query Example :CURR:DYN:L2?
2.0400
Returns current for the
specific channel.