COMMAND DETAILS
33
:CHANnel:ID?
Channel Specific
Command
Description
Queries the load module identity.
Query Syntax :CHANnel:ID?
Return Parameter <aard> Data <aard> Data
GW
Manufacturer
00000001 Serial No.
PEL2020R Channel
load id
1.00 Firmware
Version.
Query Example :CHAN:ID?
GW, PEL2020R, 00000001,
V1.00
Returns the load
module identification
string.
PEL-2000 Programming Manual
34
CONFIGURE Subsystem
:CONFigure:VOLTage:ON .......................................... 34
:CONFigure:VOLTage:RANGe .................................... 35
:CONFigure:VOLTage:LATch ...................................... 35
:CONFigure:AUTO:LOAD ........................................... 36
:CONFigure:AUTO:MODE .......................................... 37
:CONFigure:SOUND ................................................... 37
:CONFigure:REMote ................................................... 38
:CONFigure:SAVE ........................................................ 38
:CONFigure:LOAD ...................................................... 38
:CONFigure:PROTection:CURRent:STATe ................. 39
:CONFigure:PROTection:CURRent:LEVel ................... 40
:CONFigure:PROTection:VOLTage:STATe ................. 41
:CONFigure:PROTection:VOLTage:LEVel .................. 41
:CONFigure:PROTection:POWer:STATe .................... 42
:CONFigure:PROTection:POWer:LEVel ...................... 43
:CONFigure:PROTection:UVP:CLEar .......................... 43
:CONFigure:PROTection:UVP:LEVel .......................... 44
:CONFigure:VOLTage:ON
Channel Specific
Command
Description
Sets Von (voltage on value). The allowable Von
values are channel and load module specific.
Syntax :CONFigure:VOLTage:ON <NRf>[MV, V, KV ]
Parameter <NRf>[ MV, V, KV ] Von
3 3 volts
30MV 30 millivolts
30V 30 volts
Example :CONF:VOLT:ON 30MV
Set Von to 30 millivolts.
Query Syntax :CONFigure:VOLTage:ON?
To Next Page
Loading...
