INTERFACE OVERVIEW
11
GPIB Interface Configuration
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
2. Press F3(Interface Menu).
3.
4. If the interface is not set to GPIB,
use the selector knob to change
the interface to GPIB.
5. Edit the GPIB address.
Range 1 ~ 30
6. Connect the GPIB cable to
the rear panel port: 24-pin
female connector
PEL-2000 Programming Manual
12
GPIB constraints
Maximum 15 devices altogether, 20m cable
length, 2m between each device
Unique address assigned to each device
At least 2/3 of the devices turned On
No loop or parallel connection
To Next Page
Loading...
