GW Instek PEL-2002 - RUN Subsystem; Resistance:dynamic:high:t1;T2; Run

COMMAND DETAILS
97
:RESistance:DYNamic:HIGH:T1/T2
Channel Specific
Command
Description
Sets the timers T1 and T2 for high range dynamic
CR mode.
Syntax :RESistance:DYNamic:HIGH:T1/T2 <NRf+>[S|ms]
Parameter <NRf+>[S] Timer T1/T2
T1/T2 0.1S Sets the T1/T2 time to 0.1
seconds.
T1/T2 1 Sets T1/T2 to 1 second.
T1/T2 MIN Sets the T1/T2 to the
minimum value.
T1/T2 MAX Sets the T1/T2 time to the
maximum time
Example :RES:DYNA:HIGH:T1 10S
Sets the high range T1
time to 10 seconds for
the specific channel.
Query Syntax :RESistance:DYNamic:HIGH:T1/T2? [MIN, MAX]
Return Parameter <NR2>[MAX, MIN] T1/T2 time.
1 Unit=1 second Returns T1/T2 time.
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :RES:DYN:HIGH:T1?
2.5
:RES:DYN:LOW:T1? MIN
0.000025
Returns the T1 time of
2.5 seconds.
Returns the minimum T1
time allowable for the
specific channel.
PEL-2000 Programming Manual
98
RUN Subsystem
:RUN ............................................................................ 98
:RUN
All Channel
Command
Description
Turns on all the electronic loads.
Syntax :RUN
Example :RUN
Turns on all electronic
loads.