GW Instek PEL-2002 - Resistance:dynamic:low:rise;Fall; Resistance:dynamic:low:t1;T2

COMMAND DETAILS
93
L1/L2 MIN Sets L1 or L2 to the
minimum level for the
specific channel.
L1/L2 MAX Sets L1 or L2 to the
maximum Level for the
specific channel.
Example :RES:DYN:LOW:L1 10
In low range CR
dynamic mode, Set L1
(level 1) to 10 ohms.
Query Syntax :RESistance:DYNamic:LOW:L1/L2? MIN, MAX
Return Parameter <NR2>[MAX, MIN] Resistance
1 unit= 1 ohm Returns the resistance of
L1/L2.
Query Example :RES:DYN:LOW:L2? MAX
300
Returns the maximum
resistance allowed for
the channel. (PEL-2020)
:RESistance:DYNamic:LOW:RISE/FALL
Channel Specific
Command
Description
Sets the low range rising/falling slew rate for CR
dynamic mode for the specific channel.
Syntax :RESistance:DYNamic:LOW:RISE/FALL <NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew Rate
RISE/FALL 0.8A/uS Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL .1 Sets the rising/falling slew
rate to 0.1A/uS
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example :RES:DYNA:LOW:RISE 0.1
Sets the rising slew rate
to ~ 0.1A/uS.
PEL-2000 Programming Manual
94
Query Syntax :RESistance:DYNamic:LOW:RISE/FALL? [MIN, MAX]
Return Parameter <NR2>[MAX, MIN] Slew rate
1 Unit=1 amp/uS Returns the slew rate.
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :RES:DYN:LOW:FALL?
MIN
0.8000
For low range dynamic
CR mode, the minimum
value for the falling slew
rate is 0.8 A/uS for the
specific channel.
:RESistance:DYNamic:LOW:T1/T2
Channel Specific
Command
Description
Sets the timers T1 or T2 for CR dynamic mode for
the specific channel in low range.
Syntax :RESistance:DYNamic:LOW:T1/T2 <NRf+>[S|ms]
Parameter <NRf+>[S] Time T1/T2
T1/T2 0.1S Sets the T1/T2 time to 0.1
seconds.
T1/T2 1 Sets T1/T2 to 1 second.
T1/T2 MIN Sets the T1/T2 to the
minimum value.
T1/T2 MAX Sets the T1/T2 time to the
maximum time
Example :RES:DYNA:LOW:T1 10S
Sets the T1 time to 10
seconds for the specific
channel.
Query Syntax :RESistance:DYNamic:T1/T2? [MIN, MAX]
Return Parameter <NR2>[MAX, MIN] Time T1/T2
1 Unit=1 second Returns T1/T2 time.
MAX/MIN Returns the allowable
maximum and minimum.