INTERFACE OVERVIEW
5
INTERFACE OVERVIEW
This manual describes how to use the PEL-2000’s
remote command functionality and lists the
command details. The Overview chapter describes
how to configure the PEL-2000 USB/RS232/GPIB
remote control interface.
Rear Panel Overview
PEL-2004
PEL-2002
PEL-2000 Programming Manual
6
Configuring the USB Interface
USB connection PC side connector
Type A, host
PEL-2000 side
connector
Type B, device
Speed
1.1/2.0 (full speed)
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
2. Press F3(Interface Menu).
3.
4. If the interface is not USB, use the
selector knob to choose USB.
5. Connect the USB cable to the
USB-B slave port on the rear.
6. When the PC asks for the USB driver, select
pel_cdc_2000.inf (downloadable from the GW
website, www.gwinstek.com
, PEL-2000 product
corner).
To Next Page
Loading...
