GW Instek PEL-2002 - Rcl; Rdt; Rst; Sav

COMMAND DETAILS
27
Query Example *OPC?
1
All pending operations
are completed.
*RCL
Status Command
Description
The Recall Instrument State command restores the
instrument settings from a previously saved
memory setting.
Syntax *RCL <NRf>
Parameter <NRf> Recall Memory Setting
1~120 1~120
Example *RCL 1
Recalls Setting memory 1
*RDT?
System Command
Description
Returns the load module type in each channel in
order from 1~8. If no frame is present a 0 is
returned.
Query Syntax *RDT?
Return Parameter <aard> Occupied Channel
2020L PEL-2020 left channel
0 Empty channel
Query Example *RDT?
0,0,2020L,2020R,0,0,0,0
Channels 1-2 and 5-8 are
empty; 3-4 is occupied
by the PEL-2020 load
module.
*RST
Status Command
Description
Resets the mainframe by forcing the ABORt, *CLS,
and LOAD:PROT:CLE command.
Syntax *RST
Example *RST
PEL-2000 Programming Manual
28
*SAV
All Channels
Description
Saves the data memory into the specified save slot.
Syntax *SAV <NR1>
Parameter <NR1> Save slot
1~120 1~120
Example *SAV 2
Saves data memory to
save slot 2
*SRE
Status Command
Description
The Service Request Enable Command determines
which events in the Status Byte Register are
allowed to set the MSS (Master summary bit) Any
bit that is set to “1” will cause the MSS bit to be set.
See page139 for details.
Syntax *SRE <NRf>
Parameter <NRf> Bit(s) Set <NRf> Bit(s) Set
4 CSUM 32 ESB
8 QUES
16 MAV
Example *SRE 12
Sets bits CSUM and
QUES in the Service
Request Enable register.
Query Syntax *SRE?
Return Parameter <NR1> Bit(s) Set <NRf> Bit(s) Set
4 CSUM 32 ESB
8 QUES
16 MAV