GW Instek PEL-2002 - RS-232 C Interface Configuration

INTERFACE OVERVIEW
7
7. On the PC, activate a terminal application such
as MTTTY (Multi-Threaded TTY). To check the
COM port No., see the Device Manager in the
PC. For WindowsXP, select Control panel →
System → Hardware tab.
8. Run this query command via the terminal
application.
*idn?
This command should return the manufacturer,
model number, serial number, and firmware
version in the following format.
GW, PEL-2002/2004, 00000001, V1.00
9. Configuring the command interface is
completed. Refer to the other chapters for more
details.
PEL-2000 Programming Manual
8
RS-232C Interface Configuration
RS-232C
configuration
Connector
DB-9, Male
Baud rate
2400, 4800, 9600, 19200, 38400
Parity
None, Odd, Even
Data bit
8 (fixed)
Stop bit
1, 2
Panel operation
1. Press the Shift Key then the Help
key to access the Utility menu.
2. Press the Shift Key then the Help
key to access the Utility menu.
3.
03/02/09
10 : 30
O
ConfigureOther
System
Info
Interface Time SetLoad
RS232
4. If the interface is not set to RS232,
use the selector knob to change
the interface to RS232.