GW Instek PEL-2002 - Status:channel:ntransition;Ptransition; Status:csummary:enable

COMMAND DETAILS
107
Return Parameter <NR1> Event <NR1> Event
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not Used
Query Example :STAT:CHAN:EVEN?
1
An over current (OC)
event occurred since the
last time the Channel
Status Event register was
read.
:STATus:CHANnel:NTRansition/PTRansitio
n
Channel Specific
Command
Description
Determines whether a negative transition (NTR
10) or positive (PTR 01) transition in the
Channel Status Condition register will set the
corresponding event in the Channel Status Event
register.
The mask values are the bit weights of the Channel
Status PTR/NTR filters. See page 133 for details.
Syntax :STATus:CHANnel:NTRansition/PTRansition <NR1>
Parameter <NR1> Condition <NR1> Condition
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not Used
Example :STAT:CHAN:NTR 12
OP (Bit 3) and RV (Bit 4)
are set as negative
transitions.
:STAT:CHAN:PTR 1 OC (Bit 1) is set as a
positive transition.
PEL-2000 Programming Manual
108
Query Syntax :STATus:CHANnel:NTRansition/PTRansition? <NR1>
Return Parameter <NR1> Event <NR1> Event
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not Used
Query Example :STAT:CHAN:NTR?
4
OP is set as a negative
transition.
:STATus:CSUMmary:ENABle
Channel Specific
Command
Description
Determines which channels in the Channel
Summary Register group can set the CSUM bit of
the Status Byte Register. The mask values are the
bit weights of each corresponding channel in the
Channel Summary Enable Register. See page 134
for details.
Syntax :STATus:CSUMmary:ENABle <NR1>
Parameter <NR1> Event <NR1> Event
1 CH1 16 CH5
2 CH2 32 CH6
4 CH3 64 CH7
8 CH4 128 CH8
Example :STAT:CSUM: 3
Events from channel 1
and 2 are enabled
Query Syntax :STATus:CSUMmary:ENABle? <NR1>
Return Parameter <NR1> Event <NR1> Event
1 CH1 16 CH5
2 CH2 32 CH6
4 CH3 64 CH7
8 CH4 128 CH8