GW Instek PEL-2002 - Current:dynamic:low:t1;T2

COMMAND DETAILS
59
L2 2 Sets L2 to 2 Amps. (low
Range only)
L2 2A Sets L2 to 2 Amps. (low
Range only)
L1/L2 MIN Sets L1 or L2 to the
minimum level for the
specific channel.
L1/L2 MAX Sets L1 or L2 to the
maximum Level for the
specific channel.
Example :CURR:DYN:LOW:L1 10 In low range CC dynamic,
Set L1 (level 1) to 10
amps.
Query Syntax :CURRent:DYNamic:LOW:L1/L2? MIN, MAX
Return Parameter <NR2>[MAX, MIN] Current
1 unit= 1 amp Returns the current of
L1/L2, or the maximum or
minimum current allowed.
Query Example :CURR:DYN:LOW:L2?
2.0400
Returns current for the
specific channel.
:CURRent:DYNamic:LOW:RISE/FALL
Channel Specific
Command
Description
Sets the low range rising/falling slew rate for CC
dynamic mode for the specific channel.
Syntax :CURRent:DYNamic:LOW:RISE/FALL <NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew Rate
RISE/FALL 0.8A/uS Sets the rising/falling slew
rate to 0.8A/uS
RISE/FALL 1 Sets the rising/falling slew
rate to 1A/uS
PEL-2000 Programming Manual
60
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example :CURR:DYNA:LOW:RISE
1.1
Sets the rising slew rate
to 1.1A/uS.
Query Syntax : CURRent:DYNamic:LOW:RISE/FALL? [MIN, MAX]
Return Parameter <NR2>[MAX, MIN] Slew rate
1 Unit=1 amp/uS Returns the slew rate.
MAX/MIN Returns the allowable
maximum or minimum.
Query Example :CURR:DYN:LOW:FALL?
MIN
0.0003
For low range dynamic
CC mode, the minimum
allowable value for the
falling slew rate is 0.0003
A/uS for the specific
channel.
:CURRent:DYNamic:LOW:T1/T2
Channel Specific
Command
Description
Sets the low range timers T1 or T2 for CC dynamic
mode for the specific channel.
Syntax :CURRent:DYNamic:LOW:T1/T2 <NRf+>[S/ms]
Parameter <NRf+>[S/ms] Time
T1/T2 0.1S Sets the T1/T2 time to 0.1
seconds.
T1/T2 1 Sets T1/T2 to 1 second.
T1/T2 MIN Sets the T1/T2 to the
minimum value.
T1/T2 MAX Sets the T1/T2 time to the
maximum time