GW Instek PEL-2002 - Status:questionable:ntransition;Ptransition; Status:preset

COMMAND DETAILS
111
Query Syntax :STATus:QUEStionable[:EVENt]? <NR1>
Return Parameter <NR1> Event <NR1> Event
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not used
Query Example :STAT:QUES:EVEN?
1
An over current (OC)
event occurred since the
last time the
Questionable Status
Event register was read.
:STATus:QUEStionable:NTRansition/PTRan
sition
Channel Specific
Command
Description
Determines whether a negative transition (NTR
10) or positive (PTR 01) transition in the
Questionable Status Condition register will set the
corresponding event in the Questionable Status
Event register.
The mask values are the bit weights of the
Questionable Status PTR/NTR filters. See page 135
for details.
Syntax :STATus:QUEStionable:NTRansition/PTRansition
<NR1>
Parameter <NR1> Condition <NR1> Condition
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not used
PEL-2000 Programming Manual
112
Example :STAT:QUES:NTR 5
OC (Bit 1) and OP (Bit 3)
are set as negative
transitions.
:STAT:CHAN:PTR 2
OV (Bit 2) is set as a
positive transition.
Query Syntax :STATus:QUEStionable:NTRansition/PTRansition?
<NR1>
Return Parameter <NR1> Event <NR1> Event
1 OC 16 OT
2 OV 32 G/N
4 OP 64 UVP
8 RV 128~65535 Not used
Query Example :STAT:QUES:NTR?
4
Returns which
conditions (OP) have
negative transitions.
:STATus:PREset
Channel Specific
Command
Description
The status preset command resets the Enable
registers and NTR/PTR registers from the Channel
Status and Questionable Status Register groups.
Preset
Register Preset
Channel Status Enable All bits set to 1
Channel Status PTR All bits set to 1
Channel Status NTR All bits set to 0
Questionable Status Enable All bits set to 0
Questionable Status PTR All bits set to 1
Questionable Status NTR All bits set to 0
Syntax :STATus:PREset
Example :STAT:PRE