GW Instek PEL-2002 - Current:static:high:avalue;Bvalue

COMMAND DETAILS
53
AVALue MIN Sets A Value to the
minimum level for the
specific channel.
AVALue MAX Sets A Value to the
maximum Level for the
specific channel.
Example :CURR:STAT:LOW:AVAL 1
Sets low range CC static
mode A Value to 1 amp.
Query Syntax :CURRent:STATic:LOW:AVALue/BVALue?
Return Parameter <NR2>[MAX, MIN] Current
1 unit = 1 amp Returns the current of the
A or B Value.
Query Example :CURR:STAT:LOW:BVAL?
MAX
2
Returns the maximum
current allowed for the
channel. (PEL-2020)
:CURRent:STATic:LOW:RISE/FALL
Channel Specific
Command
Description
Sets the low range rising/falling slew rates.
Syntax :CURRent:STATic:LOW:RISE/FALL <NRf+>[A/uS]
Parameter <NRf+>[A/uS] Slew Rate
RISE/FALL 0.078A/uS Sets the rising/falling slew
rate to 0.078A/uS
RISE/FALL 1 Sets the rising/falling slew
rate to 1A/uS
RISE/FALL MIN Sets to the slowest
rising/falling slew rate.
RISE/FALL MAX Sets to the fastest
rising/falling slew rate.
Example
:CURR:STAT:LOW:RISE .001
Sets the rising slew rate
to 0.001A/uS.
Query Syntax : CURRent:STATic:LOW:RISE/FALL?[MIN, MAX]
PEL-2000 Programming Manual
54
Return Parameter
<NR2>[MAX, MIN] Slew rate
1 Unit=1 amp/uS Returns the slew rate.
MAX/MIN Returns the allowable
maximum and minimum.
Query Example :CURR:STAT:LOW:RISE?
MIN
0.078
For low range CC mode,
the Minimum value for
the rising slew rate is
0.078 A/uS for the
specific channel.
:CURRent:STATic:HIGH:AVALue/BVALue
Channel Specific
Command
Description
Sets the high range A/B Value for constant current
static mode.
Syntax :CURRent:STATic:HIGH:AVALue/BVALue <NRf+>[A]
Parameter NRf+[A]
AVALue 10 Sets A Value to 10 Amps.
(high range only)
BVALue 20 Sets B Value to 20 Amps.
(high Range only)
AVALue MIN Sets A Value to the
minimum level for the
specific channel.
A Value MAX Sets A Value to the
maximum Level for the
specific channel.
Example :CURRent:STATic:HIGH:AV
ALue 10
Sets high range CC static
mode A Value to 10
amps.
Query Syntax :CURRent:STATic:HIGH:AVALue/BVALue?
Return Parameter <NR2>[MAX, MIN] Auto load mode
1 unit= 1 amp Returns the current of the
A or B Value.