GW Instek PEL-2002 - Measure Subsystem; Measure:current; Measure:power; Measure:input

COMMAND DETAILS
71
Return Parameter <NR1>1unit = 1 second Load on time
2.2 2.2 seconds
Query Example :LOAD:TIME?
5.1
Returns the load on time
as 5.1 seconds.
PEL-2000 Programming Manual
72
Measure Subsystem
:MEASure:VOLTage? ................................................... 72
:MEASure:CURRent? ................................................... 72
:MEASure:POWer? ....................................................... 73
:MEASure:INPut .......................................................... 73
:MEASure:SCAN .......................................................... 74
:MEASure:ALLVoltage? ................................................ 74
:MEASure:ALLCurrent? ................................................ 75
:MEASure:ALLPower? .................................................. 75
:MEASure:VOLTage?
Channel Specific
Command
Description
This query returns the measured voltage of the
specific channel.
Query Syntax :MEASure:VOLTage? <NR2>
Return Parameter <NR2> 1 unit = 1 volt Voltage at the load input
0.5000 0.5000 volts
Query Example :MEAS:VOLT?
8.5600
A voltage of 8.56 volts is
measured at the specific
channel load input.
:MEASure:CURRent?
Channel Specific
Command
Description
This query returns the measured current of the
specific channel.
Query Syntax :MEASure:CURRent? <NR2>
Return Parameter <NR2> 1 unit = 1 amp Current at the load input
1.0000 1.0000 amps
Query Example :MEAS:CURR?
1.5
A current of 1.5 amps is
measured at the specific
channel load input.