GW Instek PEL-2002 - MODE Subsystem; Mode

COMMAND DETAILS
77
MODE Subsystem
:MODE ........................................................................ 77
:MODE
Channel Specific
Command
Description
This command sets the operating mode of the
specific channel. Some modes are load module
dependant.
Syntax :MODE:[ CCL, CCH, CCDL, CCDH, CRL, CRH,
CRDL, CRDH, CV]
Parameter <aard>
CCL CC static mode, low range
CCH CC static mode, high range
CCDL CC dynamic mode, low range
CCDH CC dynamic mode, high range
CRL CR static mode, low range
CRH CR static mode, high range
CRDL CR dynamic mode, low range
CRDH CR dynamic mode, high range
CV CV mode
Example :MODE: CCL
Set the specific channel
to low range constant
current static mode.
Query Syntax :MODE?
Return Parameter <aard> Mode
CCL CC static mode, low range
CCH CC static mode, high range
CCDL CC dynamic mode, low range
CCDH CC dynamic mode, high range
PEL-2000 Programming Manual
78
CRL CR static mode, low range
CRH CR static mode, high range
CRDL CR dynamic mode, low range
CRDH CR dynamic mode, high range
CV CV mode
Query Example :MODE?
CCH
The specific channel is
currently set to CC static
mode, high range.