GW Instek PEL-2002 - Program Subsystem; Program:sequence; Program:memory; Program:sequence:short:channel

COMMAND DETAILS
79
Program Subsystem
:PROGram:FILE .......................................................... 79
:PROGram:SEQuence ................................................. 80
:PROGram:MEMory ................................................... 80
:PROGram:SEQuence:SHORt:CHANnel ................... 81
:PROGram:SEQuence:SHORt:TIME .......................... 82
:PROGram:SEQuence:MODE .................................... 82
:PROGram:ACTive ...................................................... 83
:PROGram:CHAin ....................................................... 84
:PROGram:ONTime ................................................... 84
:PROGram:OFFTime .................................................. 85
:PROGram:RUN .......................................................... 86
:PROGram:SAVE ......................................................... 86
:PROGram:FILE
Program Number
Specific
Description
Sets the program number.
Syntax :PROGram:FILE <NR1>
Parameter <NR1> Program number
1~12 Number 1~12
Example :PROG:FILE 5
Sets the program
number to 5.
Query Syntax :PROGram:FILE?
Return Parameter <NR1> Mainframe Scanning
1-12 Returns the current
program number
Query Example :PROG:FILE?
5
The set program number
is 5.
PEL-2000 Programming Manual
80
:PROGram:SEQuence
Program Number
Specific
Description
Sets the Sequence number for the current program
number.
Syntax :PROGram:SEQuence <NR1>
Parameter <NR1> Sequence number
1~10 Number 1~10
Example :PROG:SEQ 1
Sets the sequence
number to 1 for the
current program
number.
Query Syntax :PROGram:SEQuence?
Return Parameter <NR1> Mainframe Scanning
1-10 Returns the current
sequence number
Query Example :PROG:SEQ?
1
The set sequence
number is 1.
:PROGram:MEMory
Program Number
Specific
Description
Sets the memory number used for the current
program/sequence.
Syntax :PROGram:MEMory <NR1>
Parameter <NR1> Memory number
1~120 Number 1~120
Example :PROG:MEM 1
Sets the memory number
to 001.
Query Syntax :PROGram:MEMory?
Return Parameter <NR1> Mainframe Scanning
1-120 Returns the current
program number