GW Instek PEL-2002 - Current Subsystem

COMMAND DETAILS
49
Return Parameter <NR1> Knob style
0 Old
1 Updated
Query Example :UTILITY:Load? 1
The knob style is set to
Updated.
PEL-2000 Programming Manual
50
Current Subsystem
:CURRent:STATic:L1/L2 .............................................. 50
:CURRent:STATic:RISE/FALL ...................................... 51
:CURRent:STATic:LOW:AVALue/BVALue ................... 52
:CURRent:STATic:LOW:RISE/FALL ............................. 53
:CURRent:STATic:HIGH:AVALue/BVALue ................. 54
:CURRent:STATic:HIGH:RISE/FALL ........................... 55
:CURRent:DYNamic:L1/L2 .......................................... 56
:CURRent:DYNamic:RISE/FALL .................................. 57
:CURRent:DYNamic:T1/T2 .......................................... 57
:CURRent:DYNamic:LOW:L1/L2................................. 58
:CURRent:DYNamic:LOW:RISE/FALL ........................ 59
:CURRent:DYNamic:LOW:T1/T2 ................................ 60
:CURRent:DYNamic:HIGH:L1/L2 ............................... 61
:CURRent:DYNamic:HIGH:RISE/FALL ....................... 62
:CURRent:DYNamic:HIGH:T1/T2 .............................. 63
:CURRent:STATic:L1/L2
Channel Specific
Command
Description
Sets the A/B Value for constant current static
mode, where L1 is A Value and L2 is B Value. The
command is range dependant. If the current range
is Low, then the command will only apply to the
low range settings.
Syntax :CURRent:STATic:L1|L2 <NRf+>[A]
Parameter <NRf+>[A]
L1 1 Sets A Value to 1 Amp.
L2 2 Sets B Value to 2 Amps.
L1 1A Sets A Value to 1 Amp.
(single channel only)