Hasselblad X1D II 50C User Manual

X1D II 50C USER GUIDE www.hasselblad.com
19
SAFETY
Contents
L’émetteur/récepteur exempt de licence contenu dans
le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables
aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes : (1) L’appareil ne
doit pas produire de brouillage; (2) L’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
INFORMATIONS SUR L’EXPOSITION RF
Ce dispositif (X1D MARK II; modèle X1D MARK II) est
conforme aux normes SAR pour les limites d’exposition ISED
non contrôlées et a été testé conformément aux méthodes et
procédures de mesure spéciées dans IEEE1528 et IEC 62209,
cet équipement doit être installé et fonctionne avec une
distance minimale de 1 cm entre le radiateur et votre visage
lorsque le fonctionnement est proche de l’œil. Et distance
minimale 20 cm entre le radiateur et votre corps lors de
l’opération manuelle.
Cet appareil et son (ses) antenne (s) ne doivent pas être
co-localisés ou fonctionner en conjonction avec une autre
antenne ou émetteur.
KCC WARNING MESSAGE
“해당무선설비는 운용 중 전파혼신 가능성이 있으므로
인명안전과 관련된 서비스는 할 수 없습니다.”
“해당 무선설비는 운용 중 전파혼신 가능성이 있음”
NCC WARNING MESSAGE
低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許
可，公司、商號或使用者均不得擅自變更頻率、加大功率
或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干
擾合法通信；經發現有干擾現象時，應改善至無干擾時方
得繼續使用。前項合法通信，指依電信法規定作業之無線
電通信。低功率射頻電機須忍受合法通信或工業、科學及
醫療用電波輻射性電機設備之干擾。
EU COMPLIANCE STATEMENT
VICTOR HASSELBLAD AKTIEBOLAG hereby declares that this
device is in compliance with the essential requirements and
other relevant provisions of the Directive 2014/53/EU.
EU contact address: Utvecklingsgatan 2, 41756 Göteborg,
Sweden.
FCC COMPLIANCE NOTICE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must
accept any interference received, including interference that
may cause undesired operation.
Any changes or modications not expressly approved by
the party responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV
technician for help.
RF EXPOSURE INFORMATION
This device (X1D MARK II; model: X1D MARK II) is compliance
with SAR for uncontrolled FCC exposure limits and had
been tested in accordance with the measurement methods
and Procedures specied in IEEE1528 and IEC 62209, this
equipment should be installed and operated with minimum
distance 1 cm between the radiator and your face when close
to eye operation. And minimum distance 20 cm between the
radiator and your body when hand-held operation.
This device and its antenna(s) must not be co-located or oper-
ating in conjunction with any other antenna or transmitter.
ISED WARNING
This device contains licence-exempt transmitter(s)/receiver(s)
that comply with Innovation, Science and Economic Develop-
ment Canada’s licence-exempt RSS(s). Operation is subject to
the following two conditions: (1) This device may not cause
interference. (2) This device must accept any interference,
including interference that may cause undesired operation of
the device.

Hasselblad X1D II 50C Specifications

General

Megapixel	50 MP
Camera type	MILC Body
Sensor type	CMOS
Image sensor size	- \
Image formats supported	JPEG, RAW
Maximum image resolution	8272 x 6200 pixels
Image sensor size (W x H)	43.8 x 32.9 mm
Still image resolution(s)	-
Wi-Fi	Yes
Wi-Fi standards	802.11a, 802.11b, 802.11g, Wi-Fi 4 (802.11n), Wi-Fi 5 (802.11ac)
USB version	3.2 Gen 1 (3.1 Gen 1)
USB connector	USB Type-C
Headphone outputs	1
Optical zoom	- x
Shooting modes	Auto, Manual
Self-timer delay	- s
Product color	Black
Battery voltage	7.27 V
Battery capacity	3400 mAh
Battery recharge time	2 h
Magnification	0.87 x
Viewfinder type	Electronic
Viewfinder resolution	3690000 pixels
Display diagonal	3.6 \
Display resolution (numeric)	2360000 pixels
Memory slots	2
Compatible memory cards	SD
Operating temperature (T-T)	-10 - 45 °C
Maximum video resolution	- pixels
Flash range (wide)	- m
Fastest camera shutter speed	1/10000 s
Slowest camera shutter speed	4080 s
Light metering	Centre-weighted, Evaluative (Multi-pattern), Spot
ISO sensitivity	100, 200, 400, 800, 1600, 3200, 6400, 12800, 25600
Light exposure modes	Auto
ISO sensitivity (max)	25600
ISO sensitivity (min)	100
Focus adjustment	Auto/Manual

Weight and Dimensions

Depth	70 mm
Width	148 mm
Height	97 mm
Weight	650 g
Weight (including battery)	766 g