EXPOSURE BRACKETING OPERATION
An active and pending Exposure Bracketing function, is
indicated both on the Control Screen and in Live View.
The Control Screen and Live View will show the Bracketing
Icon and the number of captures in the sequence. To see all
settings, tap the Interval Icon to show the settings screen as
described on the previous page.
In the example to the right, the Exposure Bracketing sequence
will use 3 images.
To start the sequence, press the shutter release. If you have
set an initial delay to prevent camera shake, the camera will
rst wait the pre-set number of seconds showing a black
screen with a count-down timer, and then start the Interval
sequence.
During the Exposure Bracketing sequence, the rear screen
and EVF will show an information overlay, as shown in
(A)
. If
the Shutter Speed is 1 second, the Long Exposure Screen
(B)
will be shown during exposure.
To exit from the sequence before it has been completed,
press the Cross Button.
After a capture, the last image will show up on the rear screen.
Note!
Exposure Bracketing is not supported in Phocus Mobile or
when tethered to Phocus. For tethered operation, use the
Capture Sequencer function in Phocus.
Note!
Light measurement, focusing and Auto White Balance are
performed before the rst exposure and is applied to all
images in the sequence.
Control Screen
Live View
Screen during Bracketing operation
Screen when shutter speed is 1 sec or longer.
3
3
580
+1.0 EV
Exposure Bracketing
3
Exposing
Finish Exposure
A
B
X1D II 50C USER GUIDE www.hasselblad.com
59
FUNCTIONS
Contents
To Next Page
Loading...
Need help?
General
Weight and Dimensions
