Hasselblad X1D II 50C - Clean the Sensor Filter; Clean the Lens Glass Surface

X1D II 50C USER GUIDE www.hasselblad.com
143
APPENDIX
Contents
8.3 CLEAN THE SENSOR FILTER
Caution!
Be careful when you attach/remove the components to/from
the camera. This will help prevent damage to the data bus
connections.
Caution!
When you remove the lens, keep foreign objects away from
the camera opening. The camera opening is very sensitive.
This will help prevent damage to the equipment.
Remove the Lens and clean the Sensor
1 Remove USB 3 cable if connected.
2 Press and hold the Lens Release button.
3 Rotate the Lens counter clockwise.
4 Remove the lens.
5 Carefully clean the outside surface of IR lter by using
clean compressed air.
Caution!
If you use canned compressed air to clean the glass of IR lter,
read the instructions very carefully before use. This will help
prevent damage to the lter.
If compressed air did not remove all the problems and you
still see dust spots in the images, you may have dust either on
the inside of the IR lter or on the CMOS itself, please contact
your Hasselblad dealer.
Caution!
Do not try to remove the glass IR lter from the front of the
sensor (due to dust or similar). This will cause damage to the
equipment.
8.4 CLEAN THE LENS GLASS SURFACE
REMOVE DUST
Caution!
Do not touch the glass surface with your ngers. This can
cause damage to the equipment.
If there is dust on the lens glass, do as follows:
1 Remove the dust with an air blower.
2 If that does not solve the problem, try to remove dust with
a very soft lens brush.
REMOVE SMEAR
Caution!
Do not touch the glass surface with your ngers. This can
cause damage to the equipment.
If there is smear on the lens glass, do as follows:
1 If you are not sure how to remove the smear, contact your
local Hasselblad Authorized Service Centre.
2 Clean the lens glass with a high quality lens cleaning
solution on a tissue.