X1D II 50C USER GUIDE www.hasselblad.com
INTRODUCTION
Contents
14
1.10 BATTERY
Rechargeable Battery
The environmentally approved Battery is the standard Power
Source for the X1D II Camera (1). It is advisable to keep an
extra fully recharged battery on hand. As is the case with
most batteries, problems might be encountered when used in
very low temperatures. In this situation it is advisable to keep
the reserve battery inside a warm pocket, for example, to
maintain it near body temperature.
How to remove a Battery
1 Remove the Battery
(1)
from the camera
by rotating the
Battery Lever
(2)
.
2 The Battery will move up a bit
(3)
automatically.
3 Then press the Battery in a bit but not all the way, to
release it from the Camera completely.
4 Remove the battery
(4)
.
How to mount a Battery
1 Align the battery so the contacts are facing the lens and
push it
into the Camera Battery Compartment until it locks
into place.
Note!
When the battery is inserted, the rear Status LED will show a
blink sequence once to indicate the current battery charge
level. See next page for details.
1
2
3
4