HBM QuantumX - CatmanAp

Software
QuantumX A03031_24_E00_01 HBM: public 35
S Configuration (name, connection type, TEDS, semi-automatic assignment)
S Measurement
S Activate/deactivate isochronous operation via IEEE1394b FireWire
Individual signals:
S Set sampling rates and filters (type, cut-off frequency)
Measured values (scope):
S Start/stop continuous graphic measurements (time frames, trigger, zoom)
S Basic signal analysis (X/Y cursor)
S Record measurements
Functions and outputs:
S Map inputs to outputs (scaled, filtered)
S Real-time function parameterization (RMS value, addition, multiplication),
torsional vibration analysis, limit value monitoring, matrix calculation, PID
controller
S Send measured and calculated signals in CAN FD/CAN message packages
or route CAN FD to CAN, including adaptation of data types, and save the
configuration as a database (*.DBC)
S Route signals to EtherCAT/PROFINET/xCP-on-Ethernet and save the
channel configuration as a database (*.ESI/*.GDSML/*.A2L)
Sensor database:
S Write/read sensor and calibration data on TEDS
S Add user-defined sensor data sheets, import CANdb (*.dbc)
5.2 catman®AP
The HBM "catman®AP" software is optimally suited for the following tasks:
S Setting the communication and measurement channels (integrated TEDS
editor and extendable sensor database)
S Configuration of measurement or test tasks (channels, sampling rates, trig
gers, comments, interactions)