HBM QuantumX - Page 4

4 A03031_24_E00_01 HBM: public QuantumX
6.4.7 System layout with several backplanes 54........................
7 Connecting individual QuantumX modules 55.................
7.1 Connecting the supply voltage 55...............................
7.2 Connection to host PC or data recorder 57.......................
7.2.1 Single Ethernet connection 57..................................
7.2.2 Multiple Ethernet connection with PTP synchronization 58..........
7.2.3 Multiple Ethernet connection and FireWire synchronization 59......
7.2.4 Connecting one or more QuantumX modules to the PC 59.........
7.2.5 Firmware update via Ethernet 66................................
7.2.6 Distributed setup 68...........................................
7.2.7 Layout with data recorder CX22B‐W 69..........................
7.2.8 Output measurement signals to CAN bus (MX840B) 69............
7.2.9 Output measurement signals to CAN bus (MX471C) 70............
7.2.10 Output of signals with standardized voltage in real time (MX878B or
MX879B) 71.................................................
7.2.11 Output signals in real time via EtherCAT
®
or PROFINET IRT and in
parallel via Ethernet 72........................................
8 Modules and transducers 73.................................
8.1 General information 73........................................
8.1.1 Shielding design 73...........................................
8.1.2 Active transducer connection 74................................
8.1.3 TEDS 75....................................................
8.1.4 Background calibration / autoadjustment 78......................
8.2 MX840/A/B universal amplifier 80...............................
8.2.1 MX840B pin assignment 82....................................
8.2.2 MX840B status display 83.....................................
8.3 MX440B universal amplifier 85..................................
8.4 MX410B highly dynamic universal amplifier 86....................
8.4.1 MX410B pin assignment 87....................................
8.4.2 MX410B status display 89.....................................
8.5 MX430B resistive full bridge measuring amplifier 90...............
8.5.1 MX430B pin assignment 91....................................