HBM WTX110 - Page 6

4 A4774-1.0 HBM: public WTX110
6.4.2 Configure digital I/Os (Config. Digital IO) 81.....................
6.4.3 Configure analog outputs (Configuration Analog out) 81...........
6.5 Hardware test (Test) 83......................................
6.5.1 Test digital interfaces (Test: Digital IO) 83.......................
6.5.2 Test serial interfaces (Test: Serial IO) 84.......................
6.6 Reset parameter (Reset) 85...................................
6.6.1 Reset parameter (Reset Parameter) 85.........................
6.6.2 Delete legal for trade weight memory (Reset Approved Weight) 87.
6.7 Network 87.................................................
6.8 Backup/restore (Backup) 90...................................
6.8.1 Back up/ restore using USB 90................................
7 Operating modes 92........................................
7.1 Operating mode STANDARD 92...............................
7.2 Operating mode FILLER 93...................................
7.3 Operating mode COUNT 95...................................
7.4 Application examples COUNT 98..............................
7.4.1 Counting into an empty counting 98............................
7.4.2 Counting from a full container 102...............................
7.5 Operating mode CHECK 105...................................
7.6 Application examples CHECK 109..............................
8 Application 111..............................................
8.1 General setup 111............................................
8.2 Limit switches 114............................................
8.2.1 Mode: Above level (Above level) 115............................
8.2.2 Mode Below level (Below level) 116.............................
8.2.3 Mode: Outside band (Outside band) 117.........................
8.2.4 Mode: Inside band (Inside band) 118............................
8.3 Configuration Digital I/O (Digital I/O) 118.........................
8.3.1 Configuration of the digital inputs and outputs for
Application: Standard 119......................................