HBM WTX110 - Hardware Test; Test Digital Interfaces

Service mode
WTX110 A4774-1.0 HBM: public 83
Information
The changed values are overwritten when the mode is changed!
Information
After resetting to factory defaults, the configuration for the Analog out menu
must be performed.
6.5 Hardware test (Test)
DANGER
Exercise caution when pressing the keys that control movable system parts
such as conveyor systems, flaps, etc. Before pressing these buttons, make
sure that no persons are in the danger zone of moving system parts!
For more information on the keys necessary to access this menu group, go to
the Navigation Pilot.
6.5.1 Test digital interfaces (Test: Digital IO)
Menu Key Function/Secondary selection
Test: Digital IO