HBM WTX110 - Configure Interfaces; Setting Ethernet Interface

Service mode
70 A4774-1.0 HBM: public WTX110
6.1 Configure interfaces (Interface)
For more information on the keys necessary to access this menu group, go to
the Navigation Pilot.
Information
The set values must match the setting of the corresponding peripheral devices.
6.1.1 Setting the Ethernet interface (interface: Com0 (Eth))
Menu Key Function/Secondary selection
Interface Com0 (Eth)
Com0: Port : 1234 Enter the port
Com0: Protocol AckNak Select the transfer protocol:
None Raw data only
TTY Printer control (data only)
AckNak Secure procedure with
acknowledgment
NoAck Secure procedure with
acknowledgment
→Protocol TTY selected
Com0: Codepage None Output character set:
None as per selected language
850 DOS code page 'Western Europe' for
older printers
852 DOS code page 'Central Europe'
866 DOS code page 'Russian'
Star DOS code page Star printer