HBM WTX110 - Service Mode

Service mode
WTX110 A4774-1.0 HBM: public 69
6 Service mode
To access the Service mode group select the following keys:
Menu Key Function
Standard Switch to version notice
WTX110V#.# Display the current firmware version number
Call password entry within 3 seconds
Password 324 Enter the password
1 Service mode Call Service mode
Servicemode is used to configure the weighing terminal. In addition to
configuration, Service mode includes function tests for the hardware and,
depending on the device variant (Ethernet TCP/IP, USB), the option for saving
data to a connected PC.
S Device variants for update:
- K-WTX110-A-***-**-ETH-**-***-**
- K-WTX110-A-***-**-USB-**-***-**
S The weighing terminal and connected peripheral devices may only be
configured and calibrated by qualified personnel!
S Before calling Service mode all peripherals should have been connected
and configured!
S To call Servicemode the Service password must be known.
S Inappropriate changes to settings in Service mode could result in
operational malfunctions!