HBM WTX110 - English; Table of Contents

2 A4774-1.0 HBM: public WTX110
English
1 Safety instructions 9.......................................
2 Markings used 14...........................................
2.1 The markings used in this document 14.........................
2.2 Markings used on the device 15...............................
3 System description 17......................................
4 Installation 20..............................................
4.1 Overview of connections 20...................................
4.1.1 ADM (analog sensors) 20.....................................
4.1.2 Serial interfaces 21..........................................
4.1.3 Digital inputs/outputs 22......................................
4.1.4 Analog output 24............................................
4.2 Setup and installation 24......................................
4.3 Mains connection 25.........................................
4.4 General cable assembly 26...................................
4.5 Connection of analog SG sensors 27...........................
4.5.1 Connection cable for analog load cell 29........................
4.5.2 Saving calibration data for legal for trade applications 30..........
4.6 Serial interface connection 32.................................
4.7 USB connection 35..........................................
4.8 Ethernet TCP/IP connection 35................................
4.9 Digital inputs/outputs 36......................................
4.9.1 Overview I/O Connection 37..................................
4.9.2 Overview I/O Connection with Ethernet (Modbus-TCP) Fieldbus
coupler 38..................................................
4.10 Connection of digital inputs/outputs IO (2xDO, 2xDI) 39...........
4.11 Connection of digital inputs/outputs DIO (2xDO, 1xDI) 41.........
4.12 Connection of 15-bit analog output 43..........................
4.13 Power supply for external peripheral devices 47..................
4.14 Connection to 110 … 240 VAC 48.............................