HBM WTX110 - Reset Parameters

Service mode
WTX110 A4774-1.0 HBM: public 85
6.6 Reset parameter (Reset)
For more information on the keys necessary to access this menu group, go to
the Navigation Pilot.
In this menu group you can reset all Service mode values and parameters to
their factory defaults. The calibration parameters and the network configuration
settings are not affected.
6.6.1 Reset parameter (Reset Parameter)
Menu Key Function/Secondary selection
Reset
Reset parameter? N Y Contents of Service mode will be deleted
N No action
Notice: The calibration data are not reset in this
menu!
The following table lists default values of the Service mode data to which
Reset Parameter resets.
Group in Service mode Value Value
Interface Com0: Port 1234 Com1: Ctrl. None
Com0: Protocol None Com1: Protocl. None
Com1: Baud 9600 Com1: Start char. 0
Com1: Databits 8 Com1: End char. 0
Com1: Parity None Com1: Checksum None