Operating modes
96 A4774-1.0 HBM: public WTX110
S The reference weight can be determined by entering a value or by weighing.
When the reference weight is determined by weighing, the program
automatically performs unit weight optimization. This ensures that the
counting process will run with the maximum possible accuracy.
S If too many items are placed on the scale during the optimization, an error
message appears.
S The suggested number of reference parts is 10, but it can be changed.
S Counting into an empty container or counting from a full container are both
possible.
S The setting of the outputs can be adjusted in Service
mode\Application\General Setup\Output 1 or ...\Output 2
S Switching points S1 and S2 can be set in Supervisor Mode to allow for a
tolerance check (see section 10.1 "Supervisormode/General", page 130).
S If an optical tilt sensor is connected, Input 2 is no longer available for
functions of the operating modes.
S The Generate totals function can be disabled in Supervisor Mode under
Totals? N.
To Next Page
Loading...