Hioki PW3335 - Chapter 2 Measurement; Preparations; Installation and Connection Procedures

2.1 Installation and Connection Procedures
25
Please read "Operating Precautions" (p.5) carefully before installing or connecting
the instrument. Verify that power to the measurement lines has been cut off before
connecting the instrument to them.
Measurement
Preparations Chapter 2
2.1 Installation and Connection Procedures
Install the instrument
(p.6)
1
After use, deactivate power
to the measurement lines,
disconnect cables, and
turn off the instrument.
Connect the power cord.
(p.33)
5
Turn the power on
(p.34)
6
Activate power to the
measurement lines.
7
Remove the safety
covers.
2
Reattach the safety
covers.
4
Configure the following settings as desired:
1: When you wish to use an external current sensor (p.100)
2: When you wish to use D/A output (p.85)
3: When you wish to use external control (p.82)
4: When you wish to perform synchronized measurement (p.78)
5: When you wish to use the RS-232C interface (p.123)
6: When you wish to use the LAN interface (p.116)
7: When you wish to use the GP-IB interface (p.127)
3
Connect the connection
cables to the voltage input
terminals and current input
terminals. (p.26)
1
3 5 64 72