Appendix 4 Rack Mounting
A
5
By removing the screws on the sides, this instrument can be installed in a rack mounting plate.
Rack mounting plate template diagram
(Unit: mm)
Appendix 4 Rack Mounting
Observe the following precautions regarding the mounting screws to avoid instrument
damage and electric shock accidents.
• When installing the Rack Mounting Plate, the screws must not intrude more than 6
mm into either side of the instrument.
• When removing the Rack Mounting Plate to return the instrument to stand-alone use,
replace the same screws that were installed originally. (Feet: M3 × 6 mm, Sides: M4 ×
6 mm)
When installing into the rack, reinforce the installation with a commercially available support stand.
Rack mounting plate (EIA, for mounting 1 instrument)
Rack mounting plate (EIA, for mounting 2 instruments)
Spacer (same hardware for EIA/JIS)
To Next Page
Loading...
