3.3 Integration
64
Starting integration
Stopping integration
Starting integration while adding to previous integrated values
(additional integration)
Pressing while the RUN lamp is flashing (indicating that integration is stopped) causes integration to
start while adding to previous integrated values.
1 Verify that the instrument is in the
integration reset state (RUN and
EXT lamps off).
2 Press .
Integration will start, and the RUN lamp will light
up.
Press while the RUN lamp is lit
up (indicating that the instrument is
performing integration).
Integration will stop, and the RUN lamp will flash.
As long as the integrated values are not reset, additional integration is repeated.
Press while the RUN lamp is
flashing.
Additional integration will start, and the RUN lamp
will light up.
To Next Page
Loading...
