3.3 Integration
63
Displayed integrated values
* During auto-range integration mode operation, triggers the invalid data ([- - - - -]) display.
Display method
Display of integration elapsed time
Method for starting and stopping integration and resetting integrated values
The following four methods are used to start and stop integration and reset integrated values:
• Using
• Using communications (see the Communications Command Instruction Manual)
• Using external control (p.82)
• Using synchronized control (p.78)
This section describes use of .
For more information about integration using communications, external control, or synchronized control, refer
to each section indicated above.
: Displayed − : Displays [- - - - -]
Rectifier Ah+ Ah- Ah Wh+ Wh- Wh T.AV A T.AV W
AC+DC, AC+DC Umn −−* *
DC
The display will indicate invalid data [- - - - -] if no integrated value exists.
Press through to select the display parameter.
See: "3.2.2 Selecting Display Content" (p.40)
From 0 sec. to 99 hr. 59 min. 59 sec. From 100 hr. to 999 hr. 59 min.
From 1,000 hr. to 9,999 hr. 59 min. 10,000 hr.
To Next Page
Loading...
