4.2 Operating the Instrument from a PC's Browser (LAN only)
131
Operating the instrument remotely
Selecting [Remote] on the menu displays the Remote Operation screen. The screen shown on the instrument
will be shown as-is in the browser window.
The buttons on the control panel correspond go the buttons on the instrument. You can also operate the
instrument remotely by clicking the screen with the mouse (the same key operation as the instrument).
You can save a PNG-format screenshot by clicking the [Screen copy] button.
You can also zoom in and out on most browsers by using CTRL + “+” to zoom in, CTRL + “-” to zoom out, and
CTRL + “0” to select normal size.
Instrument keys + computer’s [Shift] key
You can place the instrument in the shift state by holding down the computer’s [Shift] key while you click on keys on the
screen with your mouse.
Example: To select the rectifier
You can set rectifier by clicking the while holding down the computer’s [Shift] key.
The key lock state cannot be cancelled remotely.
Changing the rectifier
You can change the displayed rectifier by clicking on the rectifier part (DC,
AC, FND, Umn) of the measured value display area.You can also select
ACDC by holding down the computer’s [Shift] key while you click the rec-
tifier part of the display.
You can select how often
the screen is updated (up-
date speeds are about 0.3
sec [High], 1 sec [Nor-
mal], and 10 sec [Low]).
You can display a com-
ment at the top right of the
Save screen by entering
it in this field. Supported
with Internet Explorer
®
ver. 9 and later.
Changing display parameters
You can change display parameters by clicking
on the display parameters (V, A, W, VA, etc.) in
the measured value display area. You can se-
lect display parameters by using the comput-
er’s [Shift] key and [Ctrl] key.
For more information, see "Display parameter
operation chart" (p.132)
To Next Page
Loading...
