2 Press to switch to the integration
time settings screen. ([
intEG.t] will be
displayed in display area
a.)
3 Press or until the digit you
wish to set in display area
b, which will
start flashing.
4 Press or to set the integra-
tion time.
Default setting: 0000.00 (10,000 hours)
Setting range: 0000.00 to 9999.59
This indicates that the integration time cannot be changed.
After pressing to exit the setting, perform the following procedure:
Status Solution and reference for more information
During integration operation
(RUN lamp lit up or flashing)
The integration time cannot be changed until the integrated value is reset (so that
the RUN lamp turns off).
See: "Canceling integration (resetting integrated values) (DATA RESET)" (p.65)
During display hold operation or
maximum value/minimum value
hold operation (HOLD, MIN, or
MAX lamp lit up)
The integration time cannot be changed until this operation is canceled (so that the
HOLD lamp turns off).
See: "Canceling the display hold state" (p.106)
"Switching the display among the maximum, minimum, and instantaneous
values" (p.107)
If the integration time does not flash
To Next Page
Loading...
