2 UDC3300 Limit Controller Product Manual 1/01
1.1 Introduction, Continued
Mount anywhere
The UDC is industrial control equipment that must be panel mounted.
The wiring terminals must be enclosed within the panel. The UDC is
environmentally hardened and, when suitably enclosed, can be mounted
virtually anywhere in plant or factory; on the wall, in a panel, or even on
the process machine. It withstands ambient temperatures up to 55 °C
(133 °F) and resists the effects of vibration and mechanical shock.
CE Conformity
(Europe)
This product is in conformity with the protection requirements of the
following European Council Directives: 73/23/EEC, the Low Voltage
Directive, and 89/336/EEC, the EMC Directive. Conformity of this
product with any other “CE Mark” Directive(s) shall not be assumed.
Deviation from the installation conditions specified in this manual, and the
special conditions for CE conformity in Section 2.1, may invalidate this
product’s conformity with the Low Voltage and EMC Directives.
ATTENTION
The emission limits of EN 50081-2 are designed to provide reasonable protection against harmful
interference when this equipment is operated in an industrial environment. Operation of this equipment
in a residential area may cause harmful interference. This equipment generates, uses, and can radiate
radio frequency energy and may cause interference to radio and television reception when the
equipment is used closer than 30 meters (98 feet) to the antenna(e). In special cases, when highly
susceptible apparatus is used in close proximity, the user may have to employ additional mitigating
measures to further reduce the electromagnetic emissions of this equipment.
To Next Page
Loading...
Need help?
General
