1/01 UDC3300 Limit Controller Product Manual 83
7.8 Parts Replacement Procedures
Introduction
These procedures tell you how to access and replace the following printed
wiring boards in your controller.
• Display/Keyboard
• MCU/Output
• Power/Input
• Digital Input
• DMCS Communications
• RS422/485 Communications
Equipment needed
To accomplish the procedures that follow, you will need the following
equipment:
• Phillips Head Screwdriver
• Flat Bladed Screwdriver
• Small Pliers
Continued on next page
To Next Page
Loading...
Need help?
General
