Honeywell UDC3300 Product Manual

1/01 UDC3300 Limit Controller Product Manual 5
Section 2 – Installation
2.1 Overview
Introduction
Installation of the UDC3300 Limit Controller consists of mounting and
wiring the controller according to the instructions given in this section.
Read the pre-installation information, check the model number
interpretation and become familiar with your model selections, then
proceed with installation.
What’s in this
section?
This section contains the following information:
Topic See Page
2.1 Overview
2.2 Model Number Interpretation
2.3 Mounting
Physical Considerations
Overall Dimensions
Mounting Procedure
2.4 Wiring
Taking Electrical Noise Precautions
Permissible Wire Bundling
Identify Your Wiring Requirements
Control Alarm Circuit Wiring
Wiring the Controller
2.5 Wiring Diagrams
Composite Wiring Diagram
AC Line Voltage
Input #1
Output and Alarm Wiring
Digital Inputs
Communications
RS422/485
DMCS
5
7
8
8
8
9
10
10
10
11
11
11
12
12
13
14
15
16
17
17
18
Pre-installation
information
If the controller has not been removed from its shipping carton, inspect the
carton for damage and remove the controller. Inspect the unit for any
obvious shipping damage and report any damage due to transit to the
carrier.
Make sure the carton with the controller includes
• a bag containing mounting hardware and
• a bag containing input resistors.
Check that the model number shown on the inside of the case agrees with
what you have ordered.
Continued on next page

Honeywell UDC3300 Specifications

General

Brand	Honeywell
Model	UDC3300
Category	Controller
Language	English