1/01 UDC3300 Limit Controller Product Manual 19
Section 3 ā Configuration
3.1 Overview
Introduction
Configuration is a dedicated operation where you use straightforward
keystroke sequences to select and establish (configure) pertinent control
data best suited for your application.
Whatās in this
section?
The table below lists the topics that are covered in this section.
Topic See Page
3.1 Overview 19
3.2 Prompt Hierarchy 20
3.3 How to Get Started 21
3.4 Configuration Tips 22
3.5 Configuration Procedure 23
3.6 Lockout Setup Groups 25
3.7 Limit Set up Group 26
3.8 Input 1 Setup Group 27
3.9 Communications Setup Group 29
3.10 Alarms Setup Group 30
3.11 Calibration Setup Group 31
3.12 Status Set up Group 31
3.13 Configuration Record Sheet 32
Prompts
To assist you in the configuration process, there are prompts that appear in
the upper and lower displays. These prompts let you know what group of
configuration data (Set Up prompts) you are working with and also, the
specific parameters (Function prompts) associated with each group.
Figure 3-1 shows you an overview of the prompt hierarchy.
As you will see, the configuration data is divided into 5 main Set Up
groups plus prompts for calibration and prompts that show the status of
the continuous background tests that are being performed.
Continued on next page