Honeywell Vibrex 2000 User Manual

Quick Reference Guide
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
xiv
Spectrum Analysis
 Install the velocimeter in the desired location for
measurement.
 Power up the Vibrex unit.
 Press the SPECTRUM ANALYSIS context key.
 Select the velocimeter channel and azimuth sensor channel
(if used).
 Select the RPM range of interest.
 Operate the aircraft at the desired condition for taking
measurements, then press START.
 Press START to save.
Balance Reading
 Install the velocimeters and photocell, as desired, for the
aircraft to be balanced.
 Power up the Vibrex unit.
 Press the TRACK & BALANCE context key from the Main
Menu screen.
 Operate the aircraft in the desired condition.
 Press the desired channel to take measurement input.
 Press START to save.
Strobex Track
 Install the Photocell (or magnetic pickup), Strobex, and
retro- reflective targets to be viewed.
 Power up the Vibrex unit.
 Press the TRACK & BALANCE context key from the Main
Menu screen.
 Operate the aircraft in the desired condition.
Vibrex 2000 and Vibrex 2000 Plus
 Press the STROBEX TRACK context key.

Honeywell Vibrex 2000 Specifications

General

Brand	Honeywell
Model	Vibrex 2000
Category	Test Equipment
Language	English