Chapter 3 – Getting Started
Honeywell Confidential: Use or disclosure of information on this page is subject to the restrictions on the title page.
13841 Rev A
49
memory.
<PEAK LIST> Prints the 10 highest peaks for a
spectrum with the information block
for the acquisition.
<ORDER LIST> Prints the order list of half through
12th orders in half increments, if an
azimuth signal was present with the
information block for the acquisition.
<RAW FFT> Prints the vibration energy in each of
the 400 bins of the FFT with the
information block for the acquisition.
NOTE: It is not advisable to print the RAW FFT data,
using a thermal printer. Use this feature primarily for
PCs with their own software programs that generate
graphic spectra.
Printing Status Information and Fault Log - The user
may print Vibrex unit status information, as follows:
1. From the Main Menu screen, press STATUS. Allow the
Vibrex unit to complete its battery voltage and sensor power
tests. The Vibrex 2000 gives the user its test results by
showing the battery voltage and an OK or the FAIL
message for sensor power.
2. Make sure to set up the printer then press PRINT.
The resulting printout shows the status of the Vibrex 2000 or
Vibrex 2000 Plus and includes a fault log. If the unit cannot
operate or if there is an error in operation, the Vibrex unit makes
an appropriate entry in the fault log. For help in interpreting the
fault log, contact Honeywell Customer Support.
To Next Page
Loading...
Need help?
General
