HP HPE FlexNetwork 7500 series User Manual

95
Step
Command
Remarks
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Enable PIC for
OSPF.
pic
[
additional-path-always
]
By default, OSPF PIC is
enabled.
Configuring BFD for OSPF PIC
By default, OSPF PIC does not use BFD to detect primary link failures. To speed up OSPF
convergence, enable BFD for OSPF PIC to detect the primary link failures.
To configure BFD control packet mode for OSPF PIC:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Enable BFD control packet
mode for OSPF PIC.
ospf primary-path-detect bfd
ctrl
By default, BFD control packet
mode for OSPF PIC is disabled.
To configure BFD echo packet mode for OSPF PIC:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Configure the source IP
address of BFD echo
packets.
bfd echo-source-ip
ip-address
By default, the source IP address
of BFD echo packets is not
configured.
The source IP address cannot be
on the same network segment as
any local interface's IP address.
For more information about this
command, see High Availability
Command Reference.
3. Enter interface view.
interface
interface-type
interface-number
N/A
4. Enable BFD echo packet
mode for OSPF PIC.
ospf primary-path-detect bfd
echo
By default, BFD echo packet
mode for OSPF PIC is disabled.
Setting the number of OSPF logs
OSPF logs include LSA aging logs, route calculation logs, and neighbor logs.
To set the number of OSPF logs:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id
|
vpn-instance
vpn-instance-name ]
*
N/A

HP HPE FlexNetwork 7500 series Specifications

General

Brand	HP
Model	HPE FlexNetwork 7500 series
Category	Switch
Language	English