46
Peer 1.1.1.1 on Vlan-interface100
Destination/Mask Nexthop Cost Tag Flags Sec
2.1.1.0/24 1.1.1.3 1 0 RAOF 19
Local route
Destination/Mask Nexthop Cost Tag Flags Sec
1.1.1.0/24 0.0.0.0 0 0 RDOF -
10.1.1.0/24 0.0.0.0 0 0 RDOF -
10.2.1.0/24 0.0.0.0 0 0 RDOF -
Configuring RIP route redistribution
Network requirements
As shown in Figure 8, Switch B communicates with Switch A through RIP 100 and with Switch C
through RIP 200.
Configure RIP 200 to redistribute direct routes and routes from RIP 100 on Switch B so Switch C can
learn routes destined for 10.2.1.0/24 and 11.1.1.0/24. Switch A cannot learn routes destined for
12.3.1.0/24 and 16.4.1.0/24.
Figure 8 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Switch A.
<SwitchA> system-view
[SwitchA] rip 100
[SwitchA-rip-100] network 10.0.0.0
[SwitchA-rip-100] network 11.0.0.0
[SwitchA-rip-100] version 2
[SwitchA-rip-100] undo summary
[SwitchA-rip-100] quit
# Enable RIP 100 and RIP 200, and configure RIPv2 on Switch B.
<SwitchB> system-view
[SwitchB] rip 100
[SwitchB-rip-100] network 11.0.0.0
[SwitchB-rip-100] version 2
[SwitchB-rip-100] undo summary
[SwitchB-rip-100] quit
[SwitchB] rip 200
[SwitchB-rip-200] network 12.0.0.0
[SwitchB-rip-200] version 2
[SwitchB-rip-200] undo summary
Eth1/1
Vlan-int100
11.1.1.2/24
Vlan-int200
12.3.1.2/24
Vlan-int200
12
.3.1.1/24
Vlan-int400
16.4.1.1/24
Vlan
-int101
10.2.1.1/24
Vlan-int100
11.1.1.1/24
Switch A
Switch B
Switch C
RIP 100 RIP 200
To Next Page
Loading...
Need help?
General