517
1. Enter system view.
system-view
N/A
2. Create a VPN instance and
enter its view.
ip vpn-instance
vpn-instance-name
By default, no VPN instances
exist.
3. Quit VPN instance view.
quit
N/A
4. Create a loopback interface
and enter its view.
interface loopback
interface-number
By default, no loopback
interfaces exist.
5. Associate the loopback
interface with a VPN
instance.
ip binding vpn-instance
vpn-instance-name
By default, the loopback interface
is not associated with a VPN
instance.
Enabling the automatic report feature
Perform this task to enable the GNE to automatically report online or offline events of NEs to the
NMS.
To enable the automatic report feature:
1. Enter system view.
system-view
N/A
2. Enter DCN view.
dcn
N/A
3. Enable the automatic
report feature.
auto-report
By default, the automatic report
feature is disabled.
Configuring the source MAC address of LLDP
frames
Perform this task to configure the MAC address of the subinterface that runs Dot1q termination in the
specified VLAN as the source MAC address of LLDP frames. For more information about LLDP, see
Layer 2—LAN Switching Configuration Guide.
1. Enter system view.
system-view
N/A
2. Enter Layer 3 Ethernet
interface view.
interface
interface-type interface-number
N/A
3. Configure the MAC
address of the Dot1q
termination-enabled
subinterface in the
specified VLAN as the
source MAC address of
LLDP frames.
lldp source-mac vlan
vlan-id
By default, the MAC address of
the current Ethernet interface is
specified as the source MAC
address of LLDP frames.
To Next Page
Loading...
Need help?
General